Installing the Access Point
Troubleshooting Installation
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 98
Troubleshooting Installation
If the startup sequence does not work, verify that the network name (SSID) and
security settings (if you enabled them) on the AP match the settings on your wireless
device.
• Disconnect the AP from the power source, wait 5 seconds, reconnect it, and
then wait 60 seconds before attempting a reconnection.
• Disconnect and reconnect the AP and the PC.
• Replace the Ethernet cable with a new one if the relevant LAN port LED is not
illuminated. (LEDs in each port light up during a successful connection.)
If all else fails, you can reset the AP to its factory defaults (and start over).
1 Insert a straightened-out paper clip into the reset button hole.
2 Press and hold the Reset button for at least eight (6) seconds.
You can now reconnect your computer directly to the AP (as described in “2.
Connect the Access Point to the Administrative Computer” on page 86), and then
start over with installation, using the default network settings.
To Next Page
Loading...
