Installing the Access Point
Step 2: Verify Access Point Operation
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 94
3 In the list of available wireless networks, click the network with the same SSID
as you configured in “Configure Wireless # Settings” on page 89. For example,
if you set the SSID to Ruckus Wireless AP, click the wireless network named
Ruckus Wireless AP.
4 Click Connect.
Your wireless client connects to the wireless network.
Check the LEDs
Perform a spot-check using the LEDs to verify that the Access Point is operating
normally. Refer to the following sections for information on how to check the LEDs
on each ZoneFlex AP model.
Single Radio APs (ZoneFlex 7352/7351/7343/7341/7321/
7025)
If the single radio Access Point is operating normally and your wireless client was
able to associate with it:
•The WLAN LED is green.
• If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED
is off. This indicates that the Access Point is operating in standalone mode. If
there is a ZoneDirector device on the network, the DIR LED is green.
Dual Radio APs (ZoneFlex R300/7982/7962/7372/7363/
7055)
If the dual radio Access Point is operating normally and your wireless client was able
to associate with it:
•The 2.4G or 5G LED is green.
• If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED
is off. This indicates that the Access Point is operating in standalone mode. If
there is a ZoneDirector device on the network, the DIR LED is green.
To Next Page
Loading...
