Configuring the Access Point
Configuring Wireless Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 143
4 Review the options listed in Tab le 51 , and then make any needed changes.
5 Click Update Settings to save and apply the changes. A confirmation message
appears at the top of the page.
You have completed configuring the threshold options. To reopen the previous page,
click the Go back to Wireless Configuration link.
Table 51. Threshold options
Option Description
Beacon Interval (The default value is 100.) The value indicates the frequency
interval of the beacon in milliseconds. A beacon is a broadcast
packet sent by the AP to synchronize the wireless network.
Data Beacon Rate
(DTIM)
(The default value is 1.) The value indicates the interval of the
Delivery Traffic Indication Message (DTIM). This is a
countdown field that the device uses to inform its clients of
the next window for listening to broadcast or multicast
messages.
RTS/CTS Threshold (The default value is 65535.) This option determines at what
packet length the RTS/CTS function is triggered. A lower
threshold may be necessary in an environment with excessive
signal noise or hidden nodes, but may result in some
performance degradation.
To Next Page
Loading...
