Configuring the Access Point
Configuring Internet Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 121
5 To allow the DNS mode to be determined automatically, set IPV4 DNS Mode to
Auto.
To set the DNS mode manually, set IPV4 DNS Mode to Manual. Then enter the
following:
• IPv4 Primary DNS Server: The IP address of the primary Domain Name
System (DNS) server.
• IPv4 Secondary DNS Server: The IP address of the secondary DNS server.
6 Continue with Step 7 or Step 9.
Static IPv6
7 In IPv6 Connection Type, select Static IP.
8 When the Internet Connection Settings options appear, you can make changes
to the following settings:
• IPv6 Primary DNS Server: The IP address of the primary Domain Name
System (DNS) server.
• IPv6 Secondary DNS Server: The IP address of the secondary DNS server.
• IPv6 Address: Enter the static IP address that you want to assign to the AP
in IPv6 (colon-separated) format.
• IPv6 Prefix Length: Enter the prefix length for the network.
• IPv6 Gateway: Enter the gateway IP address of the Internet interface.
9 Click Update Settings to save your changes.
PPPoE
Point to Point Protocol over Ethernet (PPPoE) is a Layer 2 protocol which uses the
PPP (Point to Point) protocol to connect a client system to a server system over a
one to one network link. All traffic for a PPPoE connected client must go through
the PPPoE server to reach the client. A PPPoE server can therefore be used to
route, NAT, firewall, and perform QoS traffic shaping.
If a PPPoE server is used to distribute Internet access to subscribers, the Access
Point can be configured with a PPPoE username and password to authenticate with
the PPPoE server.
PPPoE is available only for the IPv4 connection type; PPPoE is not supported in
IPv6 environments.
1 Go to Configuration > Internet.
2 Under IPv4 Connection Type select PPPoE.
To Next Page
Loading...
