Configuring the Access Point
Configuring Wireless Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 131
Figure 65. The Configuration > Wireless > Advanced > Common page
2 Configure the advanced settings listed in Ta b l e 4 7 as required.
3 Click Update Settings to save and apply the changes.
Table 47. Advanced common wireless settings
Option Description
Transmit
Power
The default setting is
Full. Select the level of transmit power from the drop-
down menu. This option sets the maximum transmit power level relative
to the predefined power (this value differs according to the current country
code).
Protection
Mode
(Disabled by default.) If you activate protection, you control how 802.11
devices know when they should communicate with another device. This
is important in a mixed environment of both 802.11b and 802.11g/11n
clients.
CAUTION! Activating this option (and configuring the settings) boosts
the interoperability of 802.11b and 802.11g/11n devices but severely
decreases performance.
• CTS-only: Choose this option to force all destination devices to
acknowledge their ability to receive data when a transmission is initiated.
Use this option for compliance with the Wi-Fi Alliance certification.
•
RTS/CTS: Choose this option to force both sending and receiving
devices to confirm a data exchange on both ends before proceeding.
To Next Page
Loading...
