Configuring the Access Point
Configuring Hotspot Service
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 156
Acct Delay Time This attribute indicates how many seconds the client has
been trying to send this record for, and can be subtracted
from the time of arrival on the server to find the
approximate time of the event generating this
Accounting-Request. When enabled, this attribute
appears in accounting request packets with a starting
value of “0”, incremented each retry packet. When
disabled, this attribute is not included in any accounting
request packet.
NAS ID Specify the Network Access Server identifier of this
device. The NAS-ID attribute is sent in RADIUS access
and accounting request messages. It can also be used
as location identification when NAS-IP-Address cannot
be used for this purpose.
WISPr Location ID Specify the Hotspot location identifier. This value is
provided in the RADIUS access and accounting
requests. It is recommended that the value is in the form
of "
isocc=<ISO_Country_Code>,
cc=<E.164_Country_Code>,ac=<E.164_Are
a_Code>,network=<SSID/ZONE>
".
WISPr Location Name Specify the hotspot location and operator's name. This
value is provided in the RADIUS access and accounting
requests. It is recommended that the value is in the form
of "
<HOTSPOT_OPERATOR_NAME>,<Location>”.
Location Description Specify the description of location. This value is provided
in the HTTP redirection.
Accounting Update Interval Specify the interval for RADIUS accounting requests.
Interim Redirect Interval Specify the interval after which users are redirected to
the login URL.
Maximum Session Time Enter the maximum session time in minutes.
Grace Period Specify the maximum time that a user may disconnect
from the Hotspot service and return without the need to
login again.
RADIUS Disconnect Port UDP port to listen to for accepting RADIUS disconnect
requests.
Table 56. Optional Hotspot settings (Continued)
To Next Page
Loading...
