Managing the Access Point
Viewing Common Wireless Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 165
If you want to make changes to any of these settings, go to the Configuration >
Wireless page. Refer to Configuring Common Wireless Settings for more informa-
tion.
Channel Shows the wireless channel that the AP is currently using.
If you set the wireless channel to SmartSelect, this field
shows the value
Channel # [SmartSelect].
Channel Width 11n devices only. Displays whether the channel width is
set to 20MHz or 40MHz.
Country Code Shows the country code that the AP has been set to use.
CAUTION! Verify that the AP is using the correct
country code to make sure it uses only the allowed
radio channels in your region. Selecting the incorrect
country code may result in violation of applicable laws.
AeroScout RFID tag
detection
Shows Enabled if you enabled AeroScout RFID tag
detection. The default setting is
Disabled.
AeroScout Engine
communication daemon
Shows
Up if the communication agent on the AP is able
to relay location data from AeroScout Tags to the
AeroScout Engine.
If the communication agent is unable to relay data or
AeroScout tag detection is disabled, this field shows
Down.
Ekahau Engine
communication daemon
Shows Enabled if you have enabled Ekahau RFID tag
detection. Default is disabled.
ERC IP Ekahau Real Time Location System RTLS Controller IP
address.
ERC Port TCP port used by the Ekahau Real Time Location
System RTLS Controller.
Table 57. Common Wireless settings (Continued)
To Next Page
Loading...
