3 – 34 HS40 Service Manual
3.6.10.1. Menu
■ Direction
Select the Direction Type to be applied to the measurement target in the initial system status.
The options are Left and Right.
■ Location
Select the Location Type to be applied to the measurement target in the initial system status.
The options are Prox, Mid, and Dist.
■ Hide the menu on Unfreeze
Hide or show the Measurement menu on the screen after taking measurements. Show the
Scan Mode (On) or hide the Measurement menu (Off).
■ Menu Type
– Caliper then Calc: Each press of the Calculator button changes the mode in the order of
Caliper and Calc.
– Calc. then Caliper: Each press of the Calculator button changes the mode in the order of
Calc. and Caliper.
– Caliper Only: Each press of the Calculator button changes the mode to Caliper.
– Calc. Only: Each press of the Calculator button changes the mode to Calc.
3.6.10.2. Display
■ 2D Line Type
Select the type of line to use for measurement in 2D Mode (Solid: Solid line, Dot: Dotted line,
None: Start and end points) to use for measurement in 2D Mode.
■ Ellipse Cross Line
Select the type of line for measurements in 2D Mode (Solid: solid line; Dot: dotted line; and
None: start point and end point).
■ Clear Measurement(s) on Unfreeze
Show or hide measurement results on the screen when switching to Scan Mode after taking
measurements. Select this checkbox to show measurement results in 2D or M/D Mode.
■ Measurement Zoom Window
Generate an enlarged image centered around the marker. You can select On or Off.
To Next Page