Sartorius Cubis Series - Page 13

t Slide the upper draft shield panel into the guide rails from the rear while
pressing the locking tab.
t Slide the side draft shield panel into the guide rails from the rear while
pressing the locking tab.
1. Right draft shield panel
2. Left draft shield panel
y This completes the balance assembly.
Assembly for Models without a Draft Shield
t Fit parts onto the balance as shown in the picture.
1. Pan support
2. Shield plate/draft shield
3. Weighing pan
Cubis MSU User Manual 13
Getting Started
2
1
2
1
2
1
3