Schweitzer Engineering Laboratories SEL-351 - Page 5

Date Code 20001006 Manual Change Information iii
SEL-351 Instruction Manual
Revision
Date
Summary of Revisions
Appendix A:
− Updated Firmware Version information.
Appendix B:
− Added information to Step 16 in the Upgrade Procedure for Breaker Wear
Monitor data.
Appendix D:
− Updated ASCII Fast Meter Configuration Block.
− Updated ID Message.
− Updated CAS Message.
Appendix G:
− Revised Figure G.1 and Figure G.2.
− Updated Table G.2.
Appendix H:
− Corrected spelling of DECPLA, DECPLV, and DECPLM settings for DNP.
Appendix I:
− − Added MIRRORED BITS SET P Settings Sheet.
20000424 This revision includes the following literature changes (no firmware changes):
Section 4:
− Updated documentation to reflect the corrected loss-of-potential V
1
unlatch
threshold (already incorporated in firmware revisions R111 and R205.).
Appendix A:
− Corrected Firmware Version information page to add the loss-of-potential V
1
unlatch threshold changes previously updated in firmware revisions R111 and
R205.
991123 This revision includes the following changes:
Appendix H:
− Corrected documentation errors in DNP 3.0 Device Profile, page H-5.
Courtesy of NationalSwitchgear.com