Date Code 20001006 Firmware Versions A-7
SEL-351 Instruction Manual
Firmware Part/Revision No. Description of Firmware
This firmware differs from previous versions as
follows:
− Fixed LOP problem.
− Added line current values to rotating default display.
SEL-351-R104-VM
SEL-351-R104-V0
SEL-351D-R101-VM
SEL-351D-R101-V0
Model SEL-03510M; wye-connected voltages
Model SEL-035100/01/OJ; wye-connected voltages
Model SEL-0351M; delta-connected voltages
Model SEL-035100/01/OJ; delta-connected voltages
This firmware differs from previous versions as
follows:
− Added delta-connected voltages.
− Added DNP protocol.
− Added interface board support for model SEL-
035101.
SEL-351-R103-VM
SEL-351-R103-V0
SEL-351D-R100-VM
SEL-351D-R100-V0
Model SEL-03510M; wye-connected voltages
Model SEL-035100/01; wye-connected voltages
Model SEL-0351M; delta-connected voltages
Model SEL-035100/01; delta-connected voltages
This firmware differs from previous versions as
follows:
− Channel IN has an additional 0.05 A nominal
ordering option. This results in neutral ground
overcurrent elements with a more sensitive pickup
range for sensitive earth fault (SEF) applications.
SEL-351-R102-VM
SEL-351-R102-V0
Model SEL-03510M; wye-connected voltages
Model SEL-035100; wye-connected voltages
This firmware differs from previous versions as
follows:
− Added SEL-351 Relay Models 035100 and 035101
(see Table 1.1 and accompanying text).
− Relay now goes to the Lockout State for OPEN
Command execution [OPEN command now
embedded in the drive-to-lockout logic; see OPE
Command (Open Breaker) in Section 10: Serial
Port Communications and Commands].
SEL-351-R101-VM
SEL-351-R101-V0
Model SEL-03510M; wye-connected voltages
Model SEL-035100; wye-connected voltages
SEL-351-R100-VM Model SEL-03510M Original Firmware Release.
Courtesy of NationalSwitchgear.com
To Next Page
