Schweitzer Engineering Laboratories SEL-351 - Page 66

Schweitzer Engineering Laboratories SEL-351

614 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

2-26 Installation Date Code 20001006

SEL-351 Instruction Manual

Figure 2.15: Jumper, Connector, and Major Component Locations on the SEL-351 Relay

Main Board (Model 0351xT)

Courtesy of NationalSwitchgear.com

Table of Contents

Table of Contents15
- Section 1: Introduction and Specifications17
Section 2: Installation37
- Table of Contents37
- Section 2: Installation41
Section 3: Overcurrent, Voltage, Synchronism Check, Frequency, and Power Elements/Section 3: Overcurrent, Voltage, Synchronism Check, Frequency, and Power Elements75
Section 4: Loss-Of-Potential, Load Encroachment, and Directional Element Logic/Section 4: Loss-Of-Potential, Load Encroachment, and Directional Element Logic143
Section 5: Trip and Target Logic183
Section 6: Close and Reclose Logic221
Section 7: Inputs, Outputs, Timers, and Other Control Logic/Section 7: Inputs, Outputs, Timers, and Other Control Logic255
Section 8: Breaker Monitor, Metering, and Load Profile Functions/Section 8: Breaker Monitor, Metering, and Load Profile Functions305
Section 9: Setting the Relay341
Section 10: Serial Port Communications and Commands/Section 10: Serial Port Communications and Commands405
Section 11: Front-Panel Interface449
Section 12: Standard Event Reports, Sag/Swell/ Interruption Report, and Ser/Section 12: Standard Event Reports, Sag/Swell/ Interruption Report, and Ser465
- Interruption Report, and Ser467
Section 13: Testing and Troubleshooting505
Table of Contents517

Related product manuals

Preview: SEL-351R

Preview: SEL-351S

Preview: SEL-352-1

Preview: SEL-321

Preview: SEL-300G

Preview: SEL-311C

Preview: SEL-387E

Preview: SEL-787-3