HF Series Generators
T roubleshooting
TR-1005R4
61
ERROR CODE : E31
DESCRIPTION : Long exposition is not initiated.
ERROR TYPE : Indicative. Does not allow long “Exp”.
APPLICABLE TO : Nucletron Generators.
APPEARS WHEN : During exposition phase in P00 mode.
INFORMATION / SYMPTOM : Signal from K3 has not been detected after 1.6 seconds.
POSIBLE CAUSES
Signal from K3 has not been detected after 1.6 seconds.
The system is not ready to make the exposure or the operator has aborted the exposure.
ACTIONS
Release the exposure controls, press the “System Reset” push-button and check the system.
ERROR CODE : E32
DESCRIPTION : Long exposition is not cut (after 3.2 seconds) as relay K3 was not detected.
ERROR TYPE : Indicative. Cut exposition at 3.2 seconds of buckup.
APPLICABLE TO : Nucletron Generators.
APPEARS WHEN : During exposition phase in P00 mode.
INFORMATION / SYMPTOM : Signal from K3 is not received.
POSIBLE CAUSES
Signal from K3 is not received.
Exposure not completed, time is longer than 1.6 seconds.
ACTIONS
Release the exposure controls, press the “System Reset” push-button and check the system.
To Next Page
Loading...