SEEDMASTER 2023
53
CONVEYOR OPERATION
1. Reverse hydraulic flow of the oil to the seed fan. Ensure that the lids have opened, and the Arm
Lock has released the conveyor from the locked position.
NOTE: Remove any transport brackets or bolts before use.
2. Press the TILT “up” button to lift the bottom of the Conveyor out of the transport cradle.
3. Using the MAIN and 2ND ARM “out” buttons (or a combination of both), start to move the
Conveyor away from the Nova Tank.
4. Once the Conveyor is away and clear of any obstructions, use the TILT “down” button to bring
the bottom side of the Conveyor into arms reach.
NOTE: There is a handle on the bottom side of the Conveyor used to rotate the conveyor
around.
5. Using the MAIN and 2ND ARM “out” buttons (or a combination of both), start to move the
Conveyor spout in position of the desired tank to fill.
6. Once the spout is positioned, use the TILT “down” button to gently place the Conveyor on the
ground. It will rest on the clean out.
7. Position truck as necessary.
8. Unlatch the kick out Lock Hinge to allow the kick out to move down.
9. Press the KICK OUT “down” button to move the Kick Out into position. Ensure the Kick out is
all the way down before use.
10. Ensure truck chute/gate and kick out are aligned so product will flow onto the conveyor belt.
11. Start the Conveyor belt by pressing the “BELT ON/OFF” button.
NOTE: If the speed of the conveyor belt needs to be reduced, simply start closing the manual
hand belt speed valve until the desired belt speed is reached.
12. Before filling, ensure the Bin has been zeroed out on your monitor. Perform this operation
only if the bin is completely empty.
13. Begin filling by opening the truck chute/gate.
14. When the desired amount of product is in the bin close the truck chute/gate. Bin weight can be
viewed from app or remote tank monitor.
15. Allow conveyor to run for 5 – 10 seconds after closing the chute/gate to ensure the belts are
free of product. To stop the belt, press the “BELT ON/OFF” button.
16. If filling another bin or putting the conveyor into transport, press the KICK OUT “up” button and
run the Kick out up to transport position and lock in.
17. Then press the TILT “up” button to bring the conveyor off the ground.
18. Using the MAIN and 2ND ARM buttons move the conveyor back into transport or fill position
into another bin.
To Next Page
Loading...