SEEDMASTER TOOLBAR - Granular Product Control Setup (Dealer or Seedmaster Assisted Only)

SEEDMASTER 2023
81
GRANULAR PRODUCT CONTROL SETUP (DEALER
OR SEEDMASTER ASSISTED ONLY)
1. Touch the RCM working set button.
2. Touch the Settings soft key.
3. Touch the Applicator Setup tab.
4. Touch the Change/New button, the setup wizard will begin.
5. Touch the drop-down box and select new and then touch the Check Mark.
6. Enter a Profile Name.
7. Touch the Drop-Down Box for Machine Type and select Air Cart.
8. Enter an Application Width of the toolbar then touch the next button.
9. Always enter 4 for the number of Granular Products, then number the ECUs where 1 is the first
ECU inline.
10. After entering the Number of Products, touch the next button.
11. Touch the drop-down box and choose 1 or 2 for the number fans installed. Touch next.
12. Touch each drop-down box and select Granular Fertilizer or Granular Seed (lb) for each
product or Not Installed if the product does not exist. Touch next.