SEEDMASTER TOOLBAR - Single Liquid Product Control Setup (Dealer or Seedmaster Assisted Only)

SEEDMASTER 2023
84
SINGLE LIQUID PRODUCT CONTROL SETUP
(DEALER OR SEEDMASTER ASSISTED ONLY)
1. Touch the RCM working set button.
2. Touch the Settings soft key.
3. Touch the Applicator Setup tab.
4. Touch the Change/New button, the setup wizard will begin.
5. Touch the drop-down box, select New Profile, and touch the Check Mark.
6. Enter a Profile Name.
7. Touch the Drop-Down Box for Machine Type and select Liquid Fert. Tool.
8. Enter an Application Width of the toolbar then touch the next button.
9. Number the ECUs where 1 is the first ECU inline, touch next.
10. Select application type Liquid (Gal). Touch next.
11. Set the application type by touching the drop-down and selecting Liquid for the Application
Mode. Touch next.