Segway Personal Transporter i2 - Page 44

4‐10 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
6. Usetireirontoliftremainingbeadoverrim,
beingcarefulnottopinchorbindtubeor
crackplasticwheel(
Figure4‐16).
Figure4‐16:UseTireIrontoLiftRemainingBead
To avoid pinching, keep hands
and fingers away from bead
during inflation.
7. UsingairpumpwithSchradervalve
attachment(orothersourceofforcedair),
inflatetireenoughtoseattirebeads
(
Figure4‐17).Itmaybenecessarytoover‐
inflateti
retoproperlyseattirebeads.When
properlyseated,tireandwheelwillhavean
even,slightgap.Ensuretirestemisangled
45degreestowardchassis.
Figure4‐17:InflateTire
If tire is over-inflated from seating beads, release
air until pressure reaches 15 psi.
8. Installtire/wheelassembly(page4‐3).
9. Pe
rformpost‐servicetests(pageA‐1).
Finger or
hand hazard.