Segway Personal Transporter i2 - Page 68

8‐6 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
Cover motor cavity to prevent contamination.
Using a vacuum cleaner or similar tool, remove
any foreign material from motor cavity prior to
re-installation.
Figure8‐4:RemoveThreadLockCompoundfromFastener
Holes
5. Ensuregasketispresent(see”Whento
Replace”onpa
ge8‐3)andorientedproperly
ingroov
eofgearboxspacergasket.See
Figure8‐5.
Figure8‐5:AlignGearboxSpacerGasket
6. Aligncouplingsandgearboxhousingroll
pinswithchassis.(Rollpinonrightnot
pictured.)SeeFigure8‐6.
Although motor is shown out of position in
Figure 8-6 (to make couplings and roll pins
visible), motor is still in place during this
procedure.
Figure8‐6:AlignCouplingsandGearboxHousingRoll
PinswithChassis
7. Checktoensurebothgasketsareingood
conditionandproperlylocated.
8. Inspectrol
lpinstoensuretheyareinplace
onthechassisandfreeofresidue.
9. Usingrub
bermallet,gentlytapgearbox
outercoveratlocationsindicatedbyarrows
inFigure8‐7tose
atgearboxagainstchassis
untilma
tingsurfacesareflush.Alternate
strikepointsfromsidetosideforevenseat.
DO NOT STRIKE THE FLANGE OR GEARBOX!
fastener holes
Gearbox Spacer
21367-00001
rollpin