Service Manual 97
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Jack up the front of the SE-3 Patroller (Figure 130).
WARNING!
Make sure the SE-3 Patroller is stable or use a jack
stand to stabilize it while the wheel is off the ground.
Failure to stabilize the SE-3 Patroller could result in
death or serious injury from the vehicle falling over.
3. Check both bearings. If necessary, pack some
UltraLube Marine & Trailer Bearing Grease
(P/N 24431-00001) into the bearings.
4. Slide the Front Fork up into the frame (Figure 132).
5. Install the bearing and seal as shown in Figure 131.
6. Spread some Permatex Anti-Seize Lubricant
(P/N 24433-00001) on the collar nut threads. This
lubricant will make it easier to remove the collar nuts
in the future.
7. Using a SKF HN 8-9 spanner wrench, install the two
collar nuts. Torque to 45 N-m (33 ft-lbf).
8. Install the following components:
a. Handlebar (page 94)
b. Front Caliper (page 56)
c. Front Fender Bracket (page 98)
d. Front Splash Guard (page 25)
e. Front Fender (page 24)
f. Light Cluster (page 18)
g. Front Cowl (page 17)
h. Glove Box (page 16)
i. Bib Panel (page 14)
j. Storage Trays (page 13)
k. Battery Module (page 8)
9. Perform post-service tests (page 127).
Figure 132: Front Fork Removal/Installation
Front Fork
(23777-00001)
Bearing and Seal
Steering Column
To Next Page
Loading...