SE-3 Patroller24
Front Fender (Boot)
The Front Fender must be removed any time Front Fork
components need to be accessed.
Tools Required: 4 mm hex wrench
6 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Using a 6 mm hex wrench, remove the two large
fasteners (one per side). See Figure 27.
3. Using a 4 mm hex wrench, remove the four small
fasteners.(two per side).
4. Remove the Front Fender.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Place the Front Fender over the front wheel so that it
rests on the bracket.
3. Using a 6 mm hex wrench, install the two large
fasteners (one per side). See Figure 27.
Torque to 5.5 N-m (4.0 ft-lbf).
4. Using a 4 mm hex wrench, install the four small
fasteners (two per side).
Torque to 5.5 N-m (4.0 ft-lbf).
Figure 27: Front Fender Fasteners
24270-00006
5.5 N-m (4.0 ft-lbf)
24437-00003
5.5 N-m (4.0 ft-lbf)
Body Panels
To Next Page
Loading...