Service Manual 45
Battery Bumpers
The Battery Bumpers position the Battery Module at the
correct distance from the frame so that there is a good
connection between the Battery Module and the PI Board.
Tools Required: 4 mm hex wrench
8 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Front Fender (page 24)
c. Front Splash Guard (page 25)
d. Front Fender Bracket (page 98)
e. Main Splash Guard (page 26)
3. Using an 8 mm socket wrench, remove the lock nuts
holding the three brake line P-Clips to the front of the
frame. See Figure 59.
4. Slide the P-Clips off the threaded studs.
5. Using a 4 mm hex wrench, remove the Battery
Bumpers. See Figure 60.
NOTICE
Keep track of how many washers go with each
bumper. Bumper alignment is critical for maintaining
a solid battery connection. Because of variations
in the frame, different SE-3 Patrollers may have
different quantities of washers installed with the
bumpers.
Figure 59: Brake Line P-Clips
Figure 60: Battery Bumpers
Battery Bumpers
(23948-00001)
Battery Compartment
23202-00003
1.4 N-m (1.0 ft-lbf)
To Next Page
Loading...