SE-3 Patroller60
Brake Lever
Tools Required: Flathead screwdriver
10 mm socket wrench
Phillips head screwdriver
Torque wrench
UltraLube marine & trailer bearing grease
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the wheels are chocked.
CAUTION!
You can’t remove the right-hand brake lever with the
parking brake on. Chock the wheels and ensure the
SE-3 Patroller doesn’t move.
2. If removing the left-hand brake lever, proceed to
step 3 below.
If removing the right-hand brake lever, first remove
the parking brake cap:
a. Using a flathead screwdriver, remove the
retaining ring (Figure 81).
NOTICE
Be careful not to lose the retaining ring.
Since it is under spring tension, it can travel
a long distance through the air. Use your
hand to catch or deflect it so it doesn’t get
lost.
b. Slide the pin out and remove the parking
brake cap.
c. Using a phillips head screwdriver, remove
the two screws. Keep track of the spring and
lock washers.
3. Using a 10 mm socket wrench, remove the nut
underneath the brake lever (Figure 82).
4. Using a 10 mm socket wrench, unscrew and remove
the shoulder bolt (Figure 83).
5. Remove the brake lever and the parking brake
bracket, if applicable.
Figure 81: Retaining Ring
Retaining Ring
Parking
Brake Cap
Brakes
Figure 82: Nut Location
Figure 83: Parking Brake Cap Removed
Nut
10 N-m (7.4 ft-lbf)
Pin
Shoulder Bolt
10 N-m (7.4 ft-lbf)
Parking Brake
Bracket
To Next Page
Loading...