SE-3 Patroller98
Front Fender Bracket
This bracket holds the Front Fender and the Front Splashguard.
It also provides a mounting point for routing the brake line.
Tools Required: 3 mm hex wrench
4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Front Fender (page 24)
b. Front Splash Guard (page 25)
3. Using a 3 mm hex wrench, remove the P-clip that
holds the brake line to the Bracket.
4. Using a 4 mm hex wrench, remove the four fasteners
as shown in Figure 133.
5. Remove the Bracket.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Slide the Bracket onto the Front Fork.
3. Using a 4 mm hex wrench, install the four fasteners
as shown in Figure 133.
Torque to 7.5 N-m (5.5 ft-lbf).
4. Using a 3 mm hex wrench, install the P-clip to affix
the brake line to the Bracket.
5. Install the following components:
a. Front Splash Guard (page 25)
b. Front Fender (page 24)
Figure 133: Front Fender Bracket
24270-00004
7.5 N-m (5.5 ft-lbf)
Front Fender Bracket
(24155-00001)
Steering Column
To Next Page
Loading...