SE-3 Patroller120
Rear Strobe Light Harness
This harness connects the PI Board to the rear strobe lights.
Tools Required: Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Light Cluster (page 18)
g. Right Side Panel (page 20)
h. Electronics Shield (page 100)
i. Rider Detect Mat (page 82)
j. Motor Cavity Lid (page 89)
3. Disconnect the wire harness from the PI Board.
See Figure 166.
4. Remove the two cable ties on the side of the frame.
5. Using a pair of wire cutters, remove the two cable ties
at the rear of the Motor Cavity.
6. Remove the Rear Strobe Light Harness.
Figure 166: Rear Strobe Light Harness to PI Board
Figure 167: Rear Strobe Light Harness to Lights
Rear Strobe
Lights
Harnesses
To Next Page
Loading...