SE-3 Patroller14
Bib Panel
The Bib Panel is also known as the Front Tower Panel.
Tools Required: 4 mm hex wrench
2.5 mm hex wrench
Torque wrench
Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
3. Using a 4 mm hex wrench, remove the eight fasteners
as shown in Figure 7.
4. Gently pull the Bib Panel off the frame to access the
cable harnesses connected to it.
5. Disconnect the two quick connect terminals from the
back of the Accessory Power Outlet (Figure 10).
6. Using wire cutters, remove the cable tie on the
KeyLock. See Figure 9.
7. Slide the rubber protector off the KeyLock.
8. Press the tab on the side of the Connector Block and
pull it off the KeyLock (Figure 11).
9. Using a 2.5 mm hex wrench, remove the two
fasteners on the Charge Port (IEC Socket).
See Figure 8.
10. Pull the Bib Panel completely off the frame.
Figure 7: Bib Panel
24270-00006
5.5 N-m (4.0 ft-lbf)
Bib Panel
(24117-00001)
24270-00006
4.0 N-m (3.0 ft-lbf)
Body Panels
Figure 8: Charge Port
20307-00005
1.6 N-m (1.2 ft-lbf)
IEC Socket
Figure 9: Rubber Protector Covering the KeyLock
To Next Page
Loading...