SE-3 Patroller48
Glove Box Door
Tools Required: 2.5 mm hex wrench
7 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Pop off the top hinge caps (Figure 62).
3. Open the Glove Box Door and locate the fasteners on
the inside top of the Glove Box.
4. Using a 2.5 mm hex wrench and a 7 mm socket
wrench, remove the four fasteners.
5. Remove the Glove Box Door.
NOTICE
Do not operate the SE-3 Patroller without the Glove Box Door
installed. The warning label on the Glove Box Door must be
visible.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Align the Glove Box Door on the Bib Panel.
3. Insert the four fasteners from above: through the
hinges and into the holes in the Bib Panel.
4. Slide an O-ring onto the fasteners from underneath,
then slide a washer and a nut onto the fasteners.
5. Using a 2.5 mm hex wrench and a 7 mm socket
wrench, install the fasteners.
Torque to 1.6 N-m (1.2 ft-lbf).
6. Close the Glove Box Door and verify that the latch
works properly.
Figure 62: Glove Box Door
Glove Box Door
(24120-00001)
Lock Nut
(23202-00001)
1.6 N-m (1.2 ft-lbf)
20307-00005
1.6 N-m (1.2 ft-lbf)
Hinge Cap
O-ring
(24423-00001)
Washer
(20450-00001)
Bib Panel Components
To Next Page
Loading...