Service Manual 25
Front Splash Guard
The Front Splash Guard is flexible and bends around the
bracket on the Front Fork.
Tools Required: 4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the Front Fender (page 24).
3. Using a 4 mm hex wrench, remove the eight fasteners
as shown in Figure 28.
4. Remove the Front Splash Guard.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Align the Front Splash Guard against the bracket on.
Orient the part number toward the wheel.
3. Using a 4 mm hex wrench, install the eight fasteners
as shown in Figure 28.
Torque to 5.5 N-m (4.0 ft-lbf).
4. Install the Front Fender (page 24).
Figure 28: Front Splash Guard
24270-00004
5.5 N-m (4.0 ft-lbf)
Front Splash Guard
24077-00001
Body Panels
To Next Page
Loading...