SE-3 Patroller32
Windshield
Tools Required: 4 mm hex wrench
10 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Using both a 4 mm hex wrench and a 10 mm socket
wrench, remove the four hex nuts on the underside of
the Windshield. See Figure 37.
3. Remove the fasteners and lift the Windshield off the
handlebar frame.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Install four grommets into the holes in the handlebar
frame. These grommets protect the Windshield from
vibration.
3. Orient the Windshield on the SE-3 Patroller so that
the holes in the Windshield align with the holes in the
handlebar frame.
4. Insert fasteners from above. Hand tighten hex nuts
from underneath.
5. Using both a 4 mm hex wrench and a 10 mm socket
wrench, tighten the fasteners.
Torque to 1.5 N-m (1.1 ft-lbf).
NOTICE
Do not over tighten. Over tightening could damage
the Windshield.
Figure 37: Windshield
Windshield
(23802-00001)
24270-00006
23202-00004
1.5 N-m (1.1 ft-lbf)
Grommet
(23805-00001)
Windshield
To Next Page
Loading...