SE-3 Patroller72
Control Cluster
Tools Required: T15 Torx wrench
Wire cutters
Torque wrench
Digital level
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
3. Disconnect the wire harness. See Figure 103.
4. Using a pair of wire cutters, remove the two cable ties
on the steering column.
5. Using a T15 Torx wrench, loosen the three fasteners
on the under side of the Control Cluster.
See Figure 104.
6. Pull the two halves apart, and lift the Control Cluster
off the Handlebar.
Figure 103: Control Cluster Harness
Controls
To Next Page
Loading...