Service Manual 73
Figure 104: Control Cluster Fasteners
2.8 N-m (2.0 ft-lbf)
Controls
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Slide the Control Cluster onto the handlebar.
3. Leave a small gap (5 mm) between the Control
Cluster and the Handlebar Grip.
4. Orient the Control Cluster so the bottom is parallel to
the ground (0°).
5. Using a T15 Torx wrench, install the three fasteners.
Torque to 2.8 N-m (2.0 ft-lbf).
NOTICE
Tighten the fasteners carefully to make sure the two
halves align correctly with each other.
6. Connect the wire harness. See Figure 103.
7. Install two cable ties around the harnesses on the
steering column.
8. Install the following components:
a. Front Cowl (page 17)
b. Glove Box (page 16)
c. Bib Panel (page 14)
d. Storage Trays (page 13)
e. Battery Module (page 8)
9. Perform post-service tests (page 127).
To Next Page
Loading...