SE-3 Patroller44
Battery Slides
The Battery Slides orient the Battery Module in the frame.
They also allow the Battery Module to slide smoothly when
being installed or removed.
Tools Required: 2.5 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the Battery Module (page 8).
3. Using a 2.5 mm hex wrench, remove the fasteners
from the Battery Slides. See Figure 58.
4. Remove the Battery Slides.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Align the Battery Slides in the battery compartment.
3. Using a 2.5 mm hex wrench, install the fasteners.
Torque to 1.0 N-m (0.74 ft-lbf).
4. Install the Battery Module (page 8).
Figure 58: Battery Slides
20709-00001
1.0 N-m (0.74 ft-lbf)
Battery Compartment
To Next Page
Loading...