Service Manual 41
Rear Directional Light
Tools Required: 3 mm hex wrench
7 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Reach into the wheel well and disconnect the Rear
Directional Light harness. See Figure 54.
3. Use a 7 mm socket wrench, remove the lock nut and
P-clip on the back of the Brake Light. See Figure 52.
4. Using a 3 mm hex wrench, remove the two fasteners.
See Figure 53.
5. Remove the Rear Directional Light.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Feed the Rear Directional Light harness through the
hole in the Fender.
3. Reach into the wheel well and connect the harness.
4. Slide the plastic sleeves onto the fasteners, then
install the fasteners (Figure 53).
5. Using a 3 mm hex wrench, tighten the fasteners.
Torque to 1.0 N-m (0.74 ft-lbf).
CAUTION!
Do not overtighten. Overtightening may damage the
rubber seal around the light.
6. Install a P-clip around the pigtails from both the
Brake Light and Directional Light (see Figure 52).
Slide the P-clip onto the upper Brake Light fastener.
7. Using a 7 mm socket wrench, install a lock nut to hold
the P-clip in place.
Torque to 1.6 N-m (1.2 ft-lbf).
8. Perform post-service tests (page 127).
Figure 53: Rear Directional Light
24315-00004
1.0 N-m (0.74 ft-lbf)
Rear Directional Light
(24251-00001)
Figure 54: Wire Harnesses
Lights
To Next Page
Loading...