Service Manual 101
Charger
The Charger is mounted onto the same aluminum plate as the
PI Board. It can be serviced in place, or the PI Board assembly
can be removed and the Charger can be serviced on a bench.
Tools Required: 3 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Electronics Shield (page 100)
3. Disconnect the harnesses connecting the Charger to
the PI Board.
4. Using a 3 mm hex wrench, remove the four fasteners
as shown in Figure 136 and Figure 137.
5. Remove the Charger.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Orient the Charger as shown in Figure 138.
3. Using a 3 mm hex wrench, install the four fasteners
as shown in Figure 136 and Figure 137.
Torque to 2.5 N-m (1.8 ft-lbf).
4. Connect the charger harness to the PI Board.
5. Install the following components:
a. Electronics Shield (page 100)
b. Glove Box (page 16)
c. Bib Panel (page 14)
d. Storage Trays (page 13)
e. Battery Module (page 8)
6. Perform post-service tests (page 127).
Figure 136: Charger Left Side
Figure 137: Charger Right Side
24491-00003
2.5 N-m (1.8 ft-lbf)
Power Interface
To Next Page
Loading...