SE-3 Patroller42
Rear Strobe Light
Tools Required: 3 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Rider Detect Mat (page 82)
c. Motor Cavity Lid (page 89)
3. Disconnect the Rear Strobe Light harness.
See Figure 55.
4. Using a 3 mm hex wrench, remove the two fasteners.
See Figure 56.
5. Remove the Rear Strobe Light.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Feed the Rear Strobe Light harness through the hole
in the Skid Plate.
3. Connect the Rear Strobe Light harness.
See Figure 55.
4. Orient the light.
Police: Red toward center
Blue toward outside
Security: Locate the heat vent (Figure 57)
Right light = heat vent down
Left light = heat vent up.
5. Using a 3 mm hex wrench, install the two fasteners.
See Figure 56. Torque to 1.6 N-m (1.2 ft-lbf).
6. Install the following components:
a. Motor Cavity Lid (page 89)
b. Rider Detect Mat (page 82)
c. Battery Module (page 8)
7. Perform post-service tests (page 127).
Figure 55: Rear Strobe Light Harnesses
Figure 56: Rear Strobe Lights
24315-00006
1.6 N-m (1.2 ft-lbf)
Rear Strobe Light
Police 24252-00001
Security 24252-00002
Figure 57: Heat Vent Location
Heat Vent
Cap
Lights
To Next Page
Loading...