SE-3 Patroller50
Accessory Power Outlet
Tools Required: None
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
3. Unscrew the plastic nut on the back of the Accessory
Power Outlet. See Figure 65.
4. Remove the Accessory Power Outlet.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Insert the Accessory Power Outlet through the hole
on the left hand side of the Bib Panel.
3. Thread the plastic nut onto the back of the Accessory
Power Outlet.
Tighten finger tight, then turn an additional 1/8 turn.
4. Install the following components:
a. Bib Panel (page 14)
b. Storage Trays (page 13)
c. Battery Module (page 8)
5. Perform any post-service tests (page 127).
Figure 65: Accessory Power Outlet
Accessory Power Outlet
(23979-00001)
Nut
Bib Panel Components
To Next Page
Loading...