SE-3 Patroller26
Main Splash Guard
The Main Splash Guard is flexible and attaches to the frame
and to the floating bracket that holds the Front Panels
together.
Tools Required: 4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Front Fender (page 24)
b. Front Splash Guard (page 25)
c. Front Fender Bracket (page 98)
3. Using a 4 mm hex wrench, remove the eight fasteners
as shown in Figure 29.
4. Starting at the top, bend one side of the Main Splash
Guard out from behind the Side Panel. Work from top
to bottom until the entire side is released.
5. Slide the Main Splash Guard off the vehicle.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Slide the Main Splash Guard on the frame.
3. Starting at the top, bend the Main Splash Guard to fit
behind the Side Panels. Work from top to bottom.
4. Using a 4 mm hex wrench, install the eight fasteners
as shown in Figure 29.
Torque to 5.5 N-m (4.0 ft-lbf).
5. Install the following components:
a. Front Fender Bracket (page 98)
b. Front Splash Guard (page 25)
c. Front Fender (page 24)
Figure 29: Main Splash Guard
Some components not shown.
24270-00004
5.5 N-m (4.0 ft-lbf)
Main Splash Guard
24076-00001
Body Panels
To Next Page
Loading...