Service Manual 105
Maximum Speed
You can set the maximum speed of the SE-3 Patroller by using
a DIP switch located on the PI Board.
Tools Required: None
Procedure
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the Battery Module (page 8).
WARNING!
Wait 2 minutes after removing the Battery Module
before touching the PI Board. This is how long it takes
for the capacitors on the PI Board to self-discharge.
Touching the PI Board before the capacitors have
fully discharged could result in electric shock.
3. Ajust the DIP switch. See Table 3.
4. Install the Battery Module (page 8).
Validation
1. Bring the SE-3 Patroller to a large open space, such
as an empty parking lot.
2. Drive the SE-3 Patroller until it reaches maximum
speed.
3. Look at the speedometer. Verify that the displayed
speed is the desired maximum speed.
Figure 143: DIP Switch
Switch 1
Left Left Right Right
Switch 2
Left Right Left Right
Max. Speed
8 mph 10 mph 12.5 mph 15 mph
Table 3: DIP Switch Settings
Power Interface
To Next Page
Loading...