Segway SE-3 Patroller - Keylock

Service Manual 49
KeyLock
Tools Required: None
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
3. Press the tab on the side of the connector block
and pull it off the back side of the KeyLock. See
Figure 64.
4. Unscrew the plastic nut on the back of the KeyLock.
See Figure 63.
5. Remove the KeyLock.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Insert the KeyLock through the hole on the right hand
side of the Bib Panel. See Figure 63.
3. Thread the plastic nut onto the back of the KeyLock.
Tighten finger tight, then turn an additional 1/8 turn.
4. Slide the connector block onto the back of the
KeyLock until it snaps in place.
5. Install the following components:
a. Bib Panel (page 14)
b. Storage Trays (page 13)
c. Battery Module (page 8)
6. Perform any post-service tests (page 127).
Figure 63: KeyLock
KeyLock
(23969-00001)
Nut
Figure 64: KeyLock Closeup
Tab
Bib Panel Components