SE-3 Patroller74
Throttle
The throttle needs to be calibrated for the particular SE-3
Patroller it is installed on. For instructions on calibrating the
throttle contact Segway Technical Support.
Tools Required: Phillips screwdriver
Wire cutters
Torque wrench
LPS heavy duty silicone lubricant
Digital level
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
3. Disconnect the wire harness. See Figure 106.
4. Using a pair of wire cutters, remove the two cable ties
on the steering column.
5. Using a Phillips screwdriver, loosen the two fasteners
on the underside of the Throttle. See Figure 105.
6. Slide the Throttle off the handlebar.
Figure 105: Throttle
4.0 N-m (3.0 ft-lbf)
Controls
To Next Page
Loading...