Service Manual 89
Accessing the Motor Cavity
Tools Required: 3 mm hex wrench
Torque wrench
Accessing
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Light Cluster (page 18)
g. Left Side Panel (page 20)
h. Rider Detect Mat (page 82)
3. Lift off the Rider Detect Spacer.
4. Using a 3 mm hex wrench, remove the eight fasteners
as shown in Figure 120.
5. Remove the Motor Cavity Lid.
Securing
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Align the Motor Cavity Lid on the chassis/frame.
3. Using a 3 mm hex wrench, install the eight fasteners
as shown in Figure 120.
Torque to 4.0 N-m (3.0 ft-lbf).
4. Place the Rider Detect Spacer on top of the Motor
Cavity Lid.
5. Install the following components:
a. Rider Detect Mat (page 82)
b. Left Side Panel (page 20)
c. Light Cluster (page 18)
d. Font Cowl (page 17)
e. Glove Box (page 16)
f. Bib Panel (page 14)
g. Storage Trays (page 13)
h. Battery Module (page 8)
6. Perform post-service tests (page 127).
Figure 120: Motor Cavity Lid
24367-00002
4.0 N-m (3.0 ft-lbf)
Rider Detect Spacer
(23944-00001)
Drive Train
To Next Page
Loading...