Segway SE-3 Patroller - Handlebar Controls Harness

SE-3 Patroller112
Figure 151: Handlebar Controls Harness to PI Board
Figure 152: Connectors on Steering Column
Handlebar Controls Harness
This harness connects the PI Board to the Control Cluster,
Headlight, Throttle, and both Brake Levers.
Tools Required: Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Electronics Shield (page 100)
3. Disconnect the wire harness from the PI Board.
See Figure 151.
4. Disconnect the wire harness from the Control Cluster,
Headlight, Throttle, and both Brake Levers.
See Figure 152.
5. Using a pair of wire cutters, remove three cable ties:
a. This harness to the frame.
b. This harness to the User Interface Harness.
c. Harnesses on the steering column.
6. Remove the Handlebar Controls Harness.
Left
Brake Lever
Right
Brake Lever
Headlight
Throttle
Control
Cluster
Handle Bar
Harnesses