SE-3 Patroller94
Handlebar
Tools Required: 5 mm hex wrench
6 mm hex wrench
13 mm socket wrench
Wire cutters
Torque wrench
UltraLube corrosion inhibitor
Digital level
Cutting tool (box cutter or utility knife)
Heat gun
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Light Cluster (page 18)
3. Using wire cutters, remove all the cable ties on the
handlebar.
4. Disconnect the Handlebar Controls Harness along
the handlebar (page 112).
5. Using a 5 mm hex wrench, remove both Brake Levers.
See Figure 129.
NOTICE
Secure the Brake Levers so that they don’t fall or
otherwise stress the brake line.
6. Score the heat-shrink tubing with a cutting tool, then
remove the heat-shrink tubing.
CAUTION!
Be careful not to cut yourself with the sharp blade.
7. Using a 6 mm hex wrench and a 13 mm socket
wrench, remove the two fasteners as shown in
Figure 127.
8. Slide the Handlebar up and out.
Figure 127: Handlebar
Handlebar
(23798-00001)
23868-00010
23784-00001
34 N-m (25 ft-lbf)
Steering Column
Heat-Shrink Tubing
(24502-00001)
To Next Page
Loading...