SE-3 Patroller122
Accessory Power Harness
This harness connects to the Accessory Power Outlet on the
Bib Panel. It provides 12 V power.
Tools Required: Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
3. Disconnect the wire harness from the PI Board.
See Figure 169.
NOTICE
You do not need to remove the Electronics Shield to
access the Accessory Power Harnesses.
4. Using a pair of wire cutters, remove the two cable ties
around the frame.
5. Using a pair of wire cutters, remove the cable tie
holding the harness to the top of the frame.
6. Remove the Accessory Power Harness.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Connect the wire harness to the PI Board.
See Figure 169.
3. Route the harness around the right side of the frame,
and up to the top left of the frame. See Figure 170.
4. Install three cable ties:
a. One at the top of the frame.
b. Two holding the harness to the frame.
5. Install the following components:
a. Glove Box (page 16)
b. Bib Panel (page 14)
c. Storage Trays (page 13)
d. Battery Module (page 8)
6. Perform post-service tests (page 127).
Figure 169: Accessory Power Harness to PI Board
Figure 170: Accessory Power Harness Routing
Harnesses
To Next Page
Loading...