Service Manual 17
Front Cowl
The Front Cowl fastens to the left and right Side Panels.
Tools Required: 4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
3. Using a 4 mm hex wrench, remove the six fasteners
as shown in Figure 16.
4. Lift the Front Cowl off of the frame.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Place the Front Cowl onto the SE-3 so that it rests on
the Light Cluster and the Side Panels.
3. Using a 4 mm hex wrench, install the six fasteners as
shown in Figure 16.
Torque to 4.0 N-m (3.0 ft-lbf).
4. Install the following components:
a. Glove Box (page 16)
b. Bib Panel (page 14)
c. Storage Trays (page 13)
d. Battery Module (page 8)
5. Perform post-service tests (page 127).
Figure 16: Fasten the Front Cowl
24270-00004
4.0 N-m (3.0 ft-lbf)
Front Cowl
(23750-00001)
Body Panels
To Next Page
Loading...