SE-3 Patroller18
Light Cluster
These instructions describe how to remove and install the
Light Cluster body panel. For instructions on replacing
individual lights, see page 33.
Tools Required: 4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
3. Using a 4 mm hex wrench, remove the two fasteners
as shown in Figure 17.
4. Remove the two cable ties around the light cluster
harnesses.
5. Detach the wire harnesses (Figure 18).
6. Slide the Light Cluster forward and lift it off the
frame.
Figure 17: Light Cluster
24270-00006
4.0 N-m (3.0 ft-lbf)
Unpopulated
Light Cluster
(23776-00001)
Figure 18: Light Harnesses with Cable Ties
Body Panels
To Next Page
Loading...