Service Manual 19
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Slide the Light Cluster onto the frame.
NOTICE
You may need to loosen the fasteners holding the
Side Panels to the floating bracket. See Figure 20, p.
20. Be sure to torque the fasteners after installing
the Light Cluster.
3. Using a 4 mm hex wrench, install the two fasteners as
shown in Figure 17.
Torque to 4.0 N-m (3.0 ft-lbf).
4. Connect the wire harnesses. Connect the left and
right directionals to the labeled harnesses. The
strobe lights can be connected to any of the strobe
light harnesses. See Figure 19.
Right Directional Yellow + Green
Left Directional Black/White + Brown/White
5. Install two cable ties around the light harnesses to
keep them neat and safe from sharp corners.
See Figure 18.
6. Install the following components:
a. Front Cowl (page 17)
b. Glove Box (page 16)
c. Bib Panel (page 14)
d. Storage Trays (page 13)
e. Battery Module (page 8)
7. Perform post-service tests (page 127).
Strobe Lights
(Order Not Important)
Right
Directional Light
Left
Directional Light
Figure 19: Light Harness Connectors
Body Panels
To Next Page
Loading...