SE-3 Patroller70
UI Module
The UI Module is how the user interacts with the SE-3 Patroller.
NOTICE
The fault history is stored in the UI Module. Replacing the UI
Module will essentially “reset” the fault history.
Tools Required: 4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the Battery Module (page 8).
3. Using a 4 mm hex wrench, remove the four fasteners
as shown in Figure 99.
4. Disconnect the harness as shown in Figure 100.
5. Remove the UI Module.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Connect the harness as shown in Figure 100.
3. Using a 4 mm hex wrench, install the four fasteners
as shown in Figure 99.
Torque to 1.8 N-m (1.3 ft-lbf).
4. Install the Battery Module (page 8).
5. Perform post-service tests (page 127).
UI Module
(24088-00001)
24409-00003
1.8 N-m (1.3 ft-lbf)
Figure 99: UI Module
Figure 100: UI Harness
Controls
To Next Page
Loading...