SE-3 Patroller58
Front Rotor
Tools Required: 5 mm hex wrench
30 mm socket wrench (2)
Torque wrench
Vehicle jack
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Place a vehicle jack under the center front of the skid
plate. Raise the SE-3 Patroller until the front wheel is
off the ground (Figure 72).
3. Remove the following components:
a. Front Fender (page 24)
b. Front Caliper (page 56)
NOTICE
Do not disconnect the caliper from the
brake line.
4. Using a 30 mm socket wrench, remove the axle and
slide it out. See Figure 76.
5. Slide the wheel assembly out of the front fork.
6. Using a 5 mm hex wrench, remove the five fasteners
holding the rotor in place. See Figure 77.
7. Remove the Rotor.
Installation
8. Align the Rotor with the flange on the spindle.
9. Using a 5 mm hex wrench, install the five fasteners
holding the Rotor in place. See Figure 77.
Torque to 7 N-m (5 ft-lbf).
10. Slide the wheel assembly onto the front fork. Orient
the wheel assembly so the rotor flange is toward the
left side of the SE-3.
11. Slide the axle through the forks and wheel assembly.
See Figure 76.
12. Using a pair of 30 mm socket wrenches, fasten the
nut onto the axle.
Torque to 85 N-m (63 ft-lbf).
13. Install the following components:
a. Front Caliper (page 56)
b. Front Fender (page 24)
14. Perform post-service tests (page 127).
23786-00001
7.0 N-m (5.0 ft-lbf)
Front Rotor
23762-00001
24404-00001
85 N-m (63 ft-lbf)
Axle
(23773-00001)
Figure 76: Front Axle Removal
Figure 77: Front Rotor Explode
Brakes
To Next Page
Loading...