Service Manual 125
Service Interface Harness
This harness is used by service technicians when diagnosing
problems with the SE-3 Patroller.
Tools Required: Wire cutters
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Electronics Shield (page 100)
3. Disconnect the wire harness from the PI Board.
See Figure 175.
4. Remove the Service Interface Harness.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Connect the wire harness to the PI Board.
See Figure 175.
3. Install the following components:
a. Electronics Shield (page 100)
b. Glove Box (page 16)
c. Bib Panel (page 14)
d. Storage Trays (page 13)
e. Battery Module (page 8)
4. Perform post-service tests (page 127).
Figure 175: Service Interface Harness to PI Board
Service
Port
Harnesses
To Next Page
Loading...