SE-3 Patroller20
Side Panel
The Side Panels attach to a floating bracket at the front of the
steering column.
Tools Required: 4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module (page 8)
b. Storage Trays (page 13)
c. Bib Panel (page 14)
d. Glove Box (page 16)
e. Front Cowl (page 17)
f. Light Cluster (page 18)
3. Using a 4 mm hex wrench, remove the four front
fasteners (two each side) as shown in Figure 20.
4. Using a 4 mm hex wrench, remove the three side
fasteners as shown in Figure 21.
5. Using a 4 mm hex wrench, remove the bracket
fastener as shown in Figure 22.
6. Lift the Side Panel off of the frame. Pull the bottom
out then lift up.
Figure 20: Front Fasteners
Figure 21: Side Fasteners
24270-00004
4.0 N-m (3.0 in-lbf)
Side Panel
Side Panel
Left 24129-00001
Right 24130-00001
24270-00004
5.5 N-m (4.0 ft-lbf)
Body Panels
To Next Page
Loading...